Hdmi Pass Thru Settings - AMX N2412A Instruction Manual

Settings Page: Software Section
TABLE 8
Option
Model
Serial
MAC Address
Firmware Version
Web Version
Factory Restore
Reboot

HDMI Pass Thru Settings

The section of the Settings page show in
described in
HDMI Pass Thru Settings
FIG. 28
Settings Page: HDMI Pass Thru Settings
TABLE 9
Option
HDMI Pass Thru
Enable HDMI Audio
YUV Output
Simplified HDMI Detect
Invert HDMI Sync
Video Mute
Cancel
Save
N2412A/N2422A User Manual
Description
Displays the model number of the N2400 Encoder.
Displays the serial number of the N2400 Encoder.
Displays the MAC address of the network interface of the N2400 Encoder.
Displays the date code for the currently running version of the N2400 Encoder internal firmware.
Displays the date code for the currently running version of the web interface.
Click to restore the device to the original factory settings. This resets everything except the IP address
(including name, stream number, serial settings, etc.).
Click to begin a software reboot. This command does not initiate a full power cycle and does not affect the
current configuration.
Figure 28
Table 9.
Description
Enables looped output.
Determines if the unit will output audio over the HDMI connection. Selecting Auto bases audio output on the
settings of the connected source device.
For color conversion. Can force to RGB output based on connected device's reported settings. Default (and
preferred setting) is Off.
When enabled, detects HDMI solely based on the hot plug detection. Enable to help prevent displays/monitors
from going to sleep.
Inverts horizontal and vertical synchronization to the output display. Used for non-standard displays.
When enabled, the output video stream is forced to black screen.
Click to return all controls to the last saved configuration.
Click to accept changes made to these controls.
is displayed when you click the HDMI Pass Thru Settings link. Options are
Encoder Configuration Options
33