Audio In; Usb - AMX NMX-ENC-1100 Instruction Manual

Wiring and Device Connections
Consult the following table for the meaning of each LED indicator:
LED States
LED
STREAM
VIDEO IN
POWER

USB

AUDIO IN

The audio signal strength indicators show the signal strength of the selected audio source. The encoder has separate
indicators for the left and right channels. The indicators are updated every half second. FIG. 5 displays the audio signal
strength indicators.
FIG. 5 Audio Signal Strength Indicators
USB
The front panel features one Type-A USB connector for a connecting storage device and loading preset configuration
files. The port has an LED beside it which indicates the state of copying files to an attached USB drive. See the
LEDs section on page 5 for information about the LED indicator. FIG. 6 displays the USB port and LED indicator.
FIG. 6 USB port
Note: You can only retrieve information about IP configuration for the encoder from the front panel USB port. It is not
possible to retrieve IP configuration information by using the rear panel USB port.
The front USB port can only be used to retrieve encoder configuration information. A future firmware update will add
support for additional features that utilize both USB ports.
Note: The encoder is capable of simultaneously copying to devices connected to the front and rear panel.
6
OFF Green
Not streaming Streaming in
progress
No video signal of Video signal of the
the selected format is present
format present and synchronized
No power applied Power applied and
there are no
system hardware
errors
No device Attached drive can
attached. be removed
without damaging
its contents.
Blinking Green Red
N/A Streaming active
and there are one
or more streaming
errors
Unknown Signal. While actively
This signifies that streaming, an
the selected issue with the
format does not video signal
match the occurred.
detected format.
System is booting Power applied and
there are one or
more system
hardware errors
N/A Data is being
written to the
attached device.
Do not remove the
device.
Instruction Manual - NMX-ENC H.264 Encoder
Blinking Red
The streaming
engine has
stopped.
An encrypted
video signal is
being used as the
video input.
Network failure or
failure to retrieve
IP address.
N/A