AMX N2412A Instruction Manual page 14

5. Enable the Use the following IP
address option, and enter the
static IP address provided to you
by your network administrator.
NOTE: If the computer does not need Internet access, you can simply enter a unique 169.254.xxx.xxx IP address with a 255.255.0.0
subnet mask. Contact your network administrator if you are unsure of how to configure the existing network. N-Series units will not
self-assign in the 169.254.xxx.xxx range.
NOTE: If the computer has a statically-assigned IP address, click the Advanced button. Then click Add to enter a unique
169.254.xxx.xxx address with a Subnet Mask of 255.255.0.0 and a Default Gateway of 169.254.1.1.
Step 2: Connecting Decoders to the Network
The digital connection from a Decoder HDMI OUT port (female) to a display is accomplished using either an HDMI cable or DVI-D
(through adapter). N2400 units support embedded audio input and output on the HDMI ports; however, some display devices (e.g.,
many monitors) do not support embedded audio. When using such a display, use the AUDIO port for separate transmission of
sound and turn HDMI Audio Enable off (on the Settings page) to avoid video display issues.
Power is supplied via a PoE+ enabled switch or an external power supply. Refer to the following steps and
1. Using a Cat-5 cable, connect your N-Series Decoder's P0 port to a PoE+ enabled switch. This provides both network and
power connection. In non-PoE applications connect a 12V regulated power supply (FGN9313) to the two-pin terminal block
plug connector (labeled +12V 3A).
2. Connect the display you would like to use for that Decoder (monitor, projector, etc.) to the Decoder's HDMI OUT port using an
HDMI cable (or DVI through adapter). This must be a digital video connection.
Decoder Connections
FIG. 9
3. Repeat Steps 1 and 2 until all Decoders are installed on the network.
4. Once the Decoders and displays are connected and powered up, the LocalPlay screen appears on the displays.
N2412A/N2422A User Manual
N2422A Decoder
Cat-5 Cable
PoE+ Enabled Switch
Installing and Configuring Your AV Equipment
HDMI Cable
Figure 9 for guidance.
Network
14