Rs232 Settings; Effects Settings - AMX N2412A Instruction Manual

Settings Page: Advanced Settings (Cont.)
TABLE 2
Option
IR Repeat Holdoff
Relaxed Analog Input
Timing
Interleaved Multicast
Streams
Low Power Mode

RS232 Settings

The section of the Settings page shown in
Table 3.
RS232 Settings
FIG. 21
Settings Page: RS232 Settings
TABLE 3
Option
RS232 Baud Rate
RS232 Data Bits
RS232 Parity
RS232 Stop Bits

Effects Settings

The section of the Settings page shown in
Table 4.
Effects Settings
FIG. 22
Settings Page: Effects Settings
TABLE 4
Option
Border Enable
Border Size
Border Color
N2412A/N2422A User Manual
Description
Set the repeat delay between IR commands. The default
setting is 90 ms.
Enable to allow small variances in the analog input (to
avoid video interruption).
Enables a multicast format which interleaves video and
audio streams.
Enable to enable low power mode and disable all video
and audio.
Figure 21 is displayed when you click the RS232 Settings link. Options are described in
Description
Select the appropriate baud rate for the RS232 serial interface. Default is 9600.
Select the appropriate data bit count for the RS232 serial interface. Default is 8.
Select the appropriate parity for the RS232 serial interface. Default is no parity (none).
Select the appropriate number of stop bits for the RS232 serial interface. Default is 1.
Figure 22 is displayed when you click the Effects Settings link. Options are described in
Description
Enable to add a border around the video. This can help identify the video associated with a specific device.
Adjust the border size (in pixels).
Set a color for the border.
Encoder Configuration Options
Notes
This is the amount of time before a new command is
sent. For example, when pressing and holding the
volume button on a remote control, this is how long
until the command is repeated.
In order for N-Series devices to communicate with
each other, their multicast settings must be
compatible.
When enabled, the unit draws less power and
produces less heat. It also comes back up much
quicker than a full power down. Must be disabled for
the unit to work again.
29