Table of Contents
Advertisement
7
7.5
Connecting ScreenshotClient with the unit
Prerequisite:
Switch on the unit if you have not already done so
Enter the IPv4 address of the interface in the Connection input field.
You will find the address in the unit settings under: Interfaces ► Network ►
Tap Connect
A connection with the unit is established
The status message is updated
The Identifier and Language input fields become active
7.6
Configuring ScreenshotClient for taking screenshots
Once you have started ScreenshotClient, you can make the following
configurations:
Location at which screenshots are stored, and what the file names are
User interface language in which the screenshots are created
7.6.1
Configuring the storage location and file name for screenshots
By default, ScreenshotClient saves screenshots to the following storage location:
C:
HEIDENHAIN
[product code]
You can define a different storage location, if necessary.
Tap the Identifier input field
Enter the path to the storage location and the name for the screenshots into
the Identifier input field
ScreenshotClient will save all screenshots to the storage location entered
86
The network must be configured on the device.
For detailed information on configuring the network at the unit, please
refer to the "Setup" chapter in the operating instructions of QUADRA-
CHEK 2000.
Before establishing a connection with ScreenshotClient, first start the
demo software or switch on the unit. Otherwise ScreenshotClient will
show the status message Connection close. when trying to connect
[product designation]
sources
[file name]
Use the following syntax to enter the path and file name for
screenshots:
[drive]:\[folder]\[file name]
ScreenshotClient | Connecting ScreenshotClient with the unit
ProductsMGE5
HEIDENHAIN | QUADRA-CHEK 2000 Demo | User's Manual | 06/2018
Metrology
Advertisement
Table of Contents
