HEIDENHAIN QUADRA-CHEK 2000 Demo User Manual page 79

Measurement Report Template | Creating and editing a template
Selecting the data for the measurement report
The form fields listed below can be inserted into the data table of the
measurement report. During the creation of the measurement report, the data are
filled in according to the entries made and depending on the measured features.
Form field
Name
Number
Type
Cartesian position
Polar position
X
Y
Z
Coordinate system
r
φ
Size
Length
Width
Radius
Diameter
Angle
Fitting algorithm
No. of points / parent
features
Form deviation
Creation type
HEIDENHAIN | QUADRA-CHEK 2000 Demo | User's Manual | 06/2018
To insert or remove a form field, tap the form field in the list
Active form fields are indicated by a check mark
The form field is inserted as a column into the data table or
removed from the data table.
Meaning and application
The name of the feature is inserted.
The number of the feature is inserted.
The feature type is inserted.
The position in Cartesian coordinates is inserted.
The position in polar coordinates is inserted.
The X coordinate (Cartesian) is inserted.
The Y coordinate (Cartesian) is inserted.
The Z coordinate (Cartesian) is inserted.
The coordinate system that is used for the feature
is inserted.
The radial coordinate (polar) is inserted.
The angular coordinate (polar) is inserted.
The main dimension of the feature (e.g., the length
of a straight line) is inserted.
The length of the feature is inserted.
The width of the feature is inserted.
The radius of the feature is inserted.
The diameter of the feature is inserted.
The angle of the feature is inserted.
The fitting algorithms used on the feature or on the
activated tolerances are inserted.
For measured features, the number of measuring
points is inserted. For constructed features, the
number of parent features is inserted.
The maximum deviation from the calculated ideal
form is inserted.
Applies only to features that have
been measured using more than the
mathematically required number of
points.
The symbol for the process with which the feature
has been generated is inserted (measuring,
constructing, or defining).
6
79