HEIDENHAIN QUADRA-CHEK 2000 Demo User Manual page 52

5
Constructing the zero point
The zero point is constructed from the point of intersection between the alignment
and the straight line.
Figure 16: Workspace with zero point displayed in the coordinate system
52
Select Zero point in the geometry palette
Select the Alignment and Line features in the Inspector or in
the features view
The selected features are displayed in green
A new feature with the selected geometry is displayed
Tap Finish in the new feature
The zero point is created
The workpiece coordinate system for the measured object
has been determined
Tap Features preview
The coordinate system is shown in the workspace
Quick Start | Conducting a measurement
HEIDENHAIN | QUADRA-CHEK 2000 Demo | User's Manual | 06/2018