HEIDENHAIN QUADRA-CHEK 2000 Demo User Manual page 58

5
Short description
Figure 21: Overview tab in the Details dialog
1 Name of the feature
2 Axis positions of the center point
3 The coordinate system to which the coordinate values of the feature are
referenced
4 Feature parameter dependent on the geometry type: For the circle geometry
type, it is possible to switch between radius and diameter
5 Number of measuring points used for calculating the feature
6 Fitting algorithm used for calculating the feature; depends on the geometry and
the number of measuring points
7 Informational text field; if an annotation is active, then its contents are shown in
the features view as an annotation
8
List of geometry types to which the feature can be converted
9 View of the measuring points and the form
Renaming a feature
58
9
Drag the feature from the feature list into the workspace
The Details dialog appears with the Overview tab selected
Tap the input field containing the current name
Enter a new name for the feature
Confirm entry with RET
The new name is displayed in the feature list
Tap Close to close the dialog
Quick Start | Conducting a measurement
1 2
HEIDENHAIN | QUADRA-CHEK 2000 Demo | User's Manual | 06/2018
3
4
5
6
7
8