HEIDENHAIN QUADRA-CHEK 2000 Demo User Manual page 39

Basic Operation | Using the Inspector
Operating
element
HEIDENHAIN | QUADRA-CHEK 2000 Demo | User's Manual | 06/2018
Short description
Program step list
The program step list shows all actions that occur during
the measurement. It is displayed instead of the feature list
in the Inspector.
The program steps can be combined and saved as measur-
ing programs.
Auxiliary functions
The auxiliary functions contain the following functions:
Switching the display between feature list and program
step list
Creating, saving, and opening a program
Calling the program control in the workspace
Opening and saving a coordinate system
Deleting selected features or all features from the
feature list
Feature selection
Multiple selection of features of the same geometry type
Tap Feature selection
To select all features of a geometry type in the feature
list, tap the desired geometry type
Confirm with OK
The selected features are highlighted in green
Enter
Acquisition of measuring points with the following options:
If measuring point acquisition is deactivated, then the
measuring points will be acquired manually
If automatic measuring point acquisition is active, then
a red dot will be shown in the operating element. The
measuring points will be acquired after expiration of the
set timeout
3
39