Table of Contents
Advertisement
Quick Start | Conducting a measurement
Measuring a blob
A minimum of three measuring points is required to measure a blob. For
measuring point acquisition, you can use theAuto OED measuring tool, for
example. Multiple measuring points are automatically distributed along the entire
contour according to the specified settings.
Figure 20: Blob feature in the feature list with Measurement result preview
5.2.2
Displaying and editing the measurement results
You can edit the measured features immediately after capturing the measuring
points. Drag individual features into the workspace and edit them in the Details
dialog.
HEIDENHAIN | QUADRA-CHEK 2000 Demo | User's Manual | 06/2018
Select Blob in the geometry palette
Select Auto OED in the tool palette
Cross over the edge of the blob multiple times with the OED
sensor
A new feature is displayed in the feature list
A new measuring point is added for each pass over the
reference edge
Distribute the measuring points as evenly as
possible along the contour of the feature.
Tap Finish in the new feature
A new feature is calculated from the captured measuring
points and the selected geometry
The measured blob is displayed in the features preview
The measurement result preview is now displayed
5
57
Advertisement
Table of Contents
