HEIDENHAIN QUADRA-CHEK 2000 Demo User Manual page 62

5
62
Activate tolerancing of the measured value with the ON/OFF
slide switch
The selection and input fields become active
Tap the Nominal dimension input field and enter 76.2
Confirm entry with RET
Tap the Upper tolerance input field and enter 0.1
Confirm entry with RET
Tap the Lower tolerance input field and enter 0.1
Confirm entry with RET
The nominal value is shown in red if it is out of tolerance
The nominal value is shown in green if it is within tolerance
Tap Back
The Tolerances tab is displayed
Symbols are used to display the result of the tolerance check
on the Tolerances tab and, after closing the dialog, in the
feature list
Activated tolerances are maintained
One or more activated tolerances are exceed-
ed
Quick Start | Conducting a measurement
HEIDENHAIN | QUADRA-CHEK 2000 Demo | User's Manual | 06/2018