Conducting A Measurement; Measuring With An Oed Sensor - HEIDENHAIN QUADRA-CHEK 2000 Demo User Manual

Quick Start | Conducting a measurement
5.2

Conducting a measurement

5.2.1

Measuring with an OED sensor

The measurements shown here cannot be simulated with QUADRA-
CHEK 2000 Demo, because the corresponding measuring point
acquisition is not possible without a measuring device and OED sensor.
However, you can use the descriptions to familiarize yourself with the
most important functions and the user interface.
For the measurement of edges and contours with an OED sensor, various
measuring tools are available to you for the acquisition of measuring points.
Further information:
Aligning the measured object
Before you can evaluate the measuring points, you need to align the measured
object. During this process, the coordinate system of the measured object
(workpiece coordinate system) is determined, which is specified in the technical
drawing.
This makes it possible to compare the measured values with the data in the
technical drawing and assess them.
Figure 13: Example of aligning a 2-D demo part
Measured objects are usually aligned in the following steps:
1 Measuring the alignment
2 Measuring a straight line
3 Constructing the zero point
HEIDENHAIN | QUADRA-CHEK 2000 Demo | User's Manual | 06/2018
"Measuring tools", Page 40
5
49