HEIDENHAIN QUADRA-CHEK 2000 Demo User Manual page 51

Quick Start | Conducting a measurement
Measuring a straight line
A straight line is measured as the second reference edge.
Figure 15: Line feature in the feature list with Measurement result preview
HEIDENHAIN | QUADRA-CHEK 2000 Demo | User's Manual | 06/2018
Select Line in the geometry palette
Select Auto OED in the tool palette
Cross over the reference edge multiple times with the OED
sensor
A new feature is displayed in the feature list of the Inspector
A new measuring point is added for each pass over the
reference edge
Distribute the measuring points along the entire
length of the edge, as far as possible. This
minimizes the angular error.
Tap Finish in the new feature
The line is displayed in the feature list of the Inspector
The measurement result preview is now displayed
5
51