HEIDENHAIN QUADRA-CHEK 2000 Demo User Manual page 50

5
Measuring the alignment
Define the reference edge for the alignment according to the technical drawing.
Figure 14: Alignment feature in the feature list with Measurement result preview
50
Tap Measure in the main menu
Select Manual measuring in the function palette
If multiple sensors are activated, then select OED sensor in
the sensor palette
The geometry palette and the OED measuring tools are now
displayed
The workspace now shows the position display
In the quick access menu, select the magnification that is set
on the measuring machine
Select Alignment in the geometry palette
Select Auto OED in the tool palette
Cross over the reference edge multiple times with the OED
sensor
A new feature is displayed in the feature list of the Inspector
A new measuring point is added for each pass over the
reference edge
Distribute the measuring points along the entire
length of the edge, as far as possible. This
minimizes the angular error.
Tap Finish in the new feature
The alignment is displayed in the feature list of the Inspector
The measurement result preview is now displayed
Quick Start | Conducting a measurement
HEIDENHAIN | QUADRA-CHEK 2000 Demo | User's Manual | 06/2018