HEIDENHAIN QUADRA-CHEK 2000 Demo User Manual page 56

5
Measuring a slot
A minimum of five measuring points is required in order to measure a slot. For
measuring point acquisition, you can use the Auto OED measuring tool, for
example. Place at least two measuring points on the first long side and one
measuring point on the second long side, and at least one measuring point on
each arc of the slot. You can capture the points in any sequence.
Figure 19: Slot feature in the feature list with Measurement result preview
56
Select Slot in the geometry palette
Select Auto OED in the tool palette
Cross over the edge of the slot multiple times with the OED
sensor
A new feature is displayed in the feature list
A new measuring point is added for each pass over the
reference edge
Distribute the measuring points along the entire
length of the first side, as far as possible.
Tap Finish in the new feature
A new feature is calculated from the captured measuring
points and the selected geometry
The measured slot is displayed in the features preview
The measurement result preview is now displayed
Quick Start | Conducting a measurement
HEIDENHAIN | QUADRA-CHEK 2000 Demo | User's Manual | 06/2018