Service Center Calibration Or Repair - Ametek JOFRA DTI050 A Reference Manual

8.3

Service center calibration or repair

Only qualified service personnel should perform calibration, repairs,
or servicing not covered in this manual. If the indicator fails, check the
batteries first, and replace them if needed.
Verify that the indicator is being operated as explained in this manual.
If the indicator is faulty, please enclose a fully completed service
information form. Simply copy the form on the following page and fill
in the required information. Be sure to pack the indicator securely,
using the original shipping container if it is available.
Note...
If the software detects an error during operation, the error
will be shown in the display.
Make a note of the error message and contact your
distributor or AMETEK Denmark's service department.
AMETEK Denmark's liability ceases if:
•
parts are replaced/repaired using spare parts which are
not identical to those recommended by the manufacturer.
•
non-original parts are used in any way when operating
the indicator.
AMETEK Denmark's liability is restricted to errors that
originated from the factory.
42 31-08-2006 125821 00