Rsp Installation - Cisco ASR 907 Installing

RSP Installation

Figure 20: Fan Tray Removal
Warning
Step 4 Wait at least 5 seconds to allow the fans to stop spinning. Then, pull the fan tray backward toward you and
out of the chassis.
Note
This completes the steps for removing the fan tray from the chassis.
Note
To install the new fan tray, follow the steps in Installing the Fan Tray .
RSP Installation
Follow these steps on handling an RSP module in the Cisco ASR 907 Router:
Installing an RSP Module
To install an RSP module in the router chassis, perform the following steps:
Installing the Cisco ASR 907 Router
20
When removing the fan tray, keep your hands and fingers away from the spinning fan blades. Let
the fan blades completely stop before you remove the fan tray. Statement 258
As the fan tray slides out of the chassis, support the bottom of the fan tray with one hand and keep
your other hand on the fan tray handle.
The chassis must not be allowed to operate without functioning fans for more than 60 seconds.
Installing the Cisco ASR 907 Router