Cable Installation - Comtech EF Data CSAT-5060 Installation And Operation Manual

5 to 25 Watt Model C-Band Transceiver
Redundancy Installation
4.4.5 C I
ABLE NSTALLATION
Refer to Figure 4-11.
Care should be exercised in cable installation. Install the cables using the most direct route and
secure with clamps and ties. Avoid all sharp bends.
Cable connectors used in outdoors application must be sealed to avoid leakage, particularly, N-
type connectors. Moisture can seep into junctions at the plug end of the connector, between the
fixed and movable parts, and where the cable connects to the connector. Signal attenuation and
possible loss of signal can occur in the presence of moisture. All cable junctions must be sealed
with a self-amalgamating tape, such as 3M, Type 23 Scotch Self-Amalgamating tape, or
equivalent, including military style (MS) connectors.
4-11
Revision 1
MN/CSAT506025.IOM