Comtech EF Data CSAT-5060 Installation And Operation Manual page 96

5 to 25 Watt C-Band Transceiver
Remote Control
Arguments
for
Command
Command
or
(Instruction
Parameter
Response
Code and
Type
to Query
qualifier)
Redundancy RAM= 1 byte,
Controller value of 0,1
Box
Auto/Manual
Mode
Redundancy RTG= None
Controller
Box Toggle
Remote SPA= 4 bytes,
Address numerical
(Physical
Address)
Remote SBR= 4 bytes
Baud rate
Set RTC DAY= 6 bytes,
Date numerical
Description of arguments
Note that all arguments are ASCII
numeric codes between 48 and 57.
Command or Query.
RAM controls whether or not the Redundancy Controller
is in automatic or manual mode, where:
0 = Manual Mode,
1 = Auto Mode.
Example: RAM=1
Note: Access via the Online unit.
Command only.
RTG= sent to the online CSAT will cause the
Redundancy Box to toggle the TX and RX switches.
Example: RTG=
Command or Query.
Physical Address - between 0001 and 9999.
Resolution 0001.
Example: SPA=0890
Command or Query.
Baud Rate, as follows:
1200 = 1200 baud,
2400 = 2400 baud,
4800 = 4800 baud,
9600 = 9600 baud,
19K2 = 19200 baud.
38K4 = 38400 baud.
Note: Unit responds on the existing baud rate and then
changes to the new baud rate.
A command in the form mmddyy, where; dd = day of the
month, between 01 and 31, mm = month of the year,
between 01 and 12 and yy = year, between 97 and 96
(1997 to 2000, then 2000 to 2096)
Example: DAY=042457 would be April 24, 2057
Response to
Command
(Slave to Master)
RAM= (message ok)
RAM? (received ok,
but invalid
arguments found)
RTG= (message ok)
RTG? (received ok,
but invalid
arguments found)
SPA= (message ok)
SPA? (received ok,
but invalid
arguments found)
SBR= (message ok)
SBR? (received ok,
but invalid
arguments found)
DAY= (message ok)
DAY? (received ok,
but invalid
arguments found)
DAY* (message ok,
but not permitted in
current mode
A-12
MN/CSAT506025.IOM
Query
(Instruction Response to query
code and
(Slave to Master)
qualifier)
RAM? RAM=x
(same format as command
arguments)
N/A N/A
SPA? SPA=xxxx
(same format as command
arguments)
SBR? SBR=xxxx
(same format as command
arguments)
DAY? DAY=xxxxxx
(same format as command
arguments
Revision 1