Table of Contents
Advertisement
2.1
Unpacking and Inspection
Inspect shipping containers for damage. If shipping containers are damaged, keep them until the
contents of the shipment have been carefully inspected and checked for normal operation.
The MBT-5003 L-Band Up/Down Converter System and its Installation and Operation Manual
are packaged and shipped in a pre-formed, reusable cardboard carton containing foam spacing for
maximum shipping protection.
Do not use any cutting tool that will extend more than 1" into the container
and cause damage to the transceiver.
CAUTION
Unpack and inspect the MBT-4000 as follows:
Step
Procedure
Cut the tape at the top of the carton indicated by OPEN THIS END.
1
2
Remove the cardboard/foam space covering the MBT-4000.
3
Remove the MBT-4000 and manual from the carton.
4
Save the packing material for storage or reshipment purposes.
5
Inspect the equipment for any possible damage incurred during shipment.
6
Check the equipment against the packing list to ensure the shipment is correct.
7
Refer to the next section (Section 2.2) for installation instructions.
Chapter 2. INSTALLATION
2–1
Advertisement
Table of Contents
Need help?
Do you have a question about the MBT-4000 and is the answer not in the manual?
Questions and answers