Comtech EF Data CSAT-5060 Installation And Operation Manual page 91

5 to 25 Watt C-Band Transceiver
Remote Control
Arguments
for
Command
Command
or
(Instruction
Parameter
Response
Code and
Type
to Query
qualifier)
TX UFQ= 6 bytes
Frequency numerical
RX DFQ= 6 bytes
Frequency numerical
TX UAT= 5 bytes
Attenuation numerical
RX DAT= 5 bytes
Attenuation numerical
TX Gain UGO= 5 bytes
Offset numerical
RX Gain DGO= 5 bytes
Offset numerical
TX Amplifier AMP= 1 byte,
value of
0,1
Description of arguments
Note that all arguments are ASCII
numeric codes between 48 and 57.
Command or Query.
TX Frequency in valid range.
Frequency divisible by 1MHz and 2.5 MHz are allowed.
Example: UFQ= 5901.0
Command or Query.
RX Frequency in valid range.
Frequency divisible by 1MHz and 2.5 MHz are allowed.
Example: DFQ=3652.5
Command or Query.
TX Attenuation, in dB, between 00.00 and 25.00.
Resolution = 00.25 dB.
Example: UAT=12.75
Command or Query.
RX Attenuation, in dB, between 00.00 and 20.00.
Resolution = 00.25 dB.
Example: DAT=12.75
Command or Query.
TX Gain Offset for 1:1 redundancy configurations.
In dB, between -0.00 and -4.00. Resolution = 00.25 dB.
Example: UGO=-1.25
Command or Query.
RX Gain Offset for 1:1 redundancy configurations.
In dB, between -0.00 and -4.00. Resolution = 00.25 dB.
Example: DGO=-1.25
Command or Query.
TX Amplifier, where:
0 = Amplifier OFF
1 = Amplifier ON
Example: AMP=1
Response to
Command
(Slave to Master)
UFQ= (message ok)
UFQ? (received ok,
but invalid
arguments found)
DFQ= (message ok)
DFQ? (received ok,
but invalid
arguments found)
UAT= (message ok)
UAT? (received ok,
but invalid
arguments found)
DAT= (message ok)
DAT? (received ok,
but invalid
arguments found)
UGO= (message ok)
UGO? (received ok,
but invalid
arguments found)
DGO= (message ok)
DGO? (received ok,
but invalid
arguments found)
AMP= (message ok)
AMP? (received ok,
but invalid argument
found)
A-7
MN/CSAT506025.IOM
Query
(Instruction Response to query
code and
(Slave to Master)
qualifier)
UFQ? UFQ=xxxx.x (same format as
command arguments)
DFQ? DFQ=xxxx.x (same format as
command arguments)
UAT? UAT=xx.xx
(same format as command
arguments)
DAT? DAT=xx.xx
(same format as command
arguments)
UGO? UGO=xx.xx
(same format as command
arguments)
DGO? DGO=xx.xx
(same format as command
arguments)
AMP? AMP=x
(same format as command
argument)
Revision 1