Comtech EF Data CSAT-5060 Installation And Operation Manual page 28

5 to 25 Watt Model C-Band Transceiver
Single-Thread Installation
4. Position the Unistrut bracket (1) with pipe blocks (11) against the mounting pole, slide the
pipe blocks (11) until they contact the mounting pole. Ensure the pipe blocks (11) are
centered to the Unistrut bracket (1). Tighten the hardware.
5. Attach bracket (5, figure 2-1) to the strap (4) using two nuts (10), two flat washers, (7),
and two split washers (8).
6. Place the assembly against the pole with the strap around the pole and trim the strap to fit
as shown in Figure 2-5, using the tin snips. Attach bracket (3, figure
2-1) to the strap (4) using two nuts (10), two flat washers (7), and two split washers (8).
7. Slide tensioner bracket (2) into channel of the Unistrut bracket (1). Place assembly on the
pole. Slide bracket (3) over bracket (2).
8. Place flat washer (7) and split washer (8), and nut (10) on bracket (2). Tighten nut to
secure the tension strap.
9.
Slide two springnuts, (5, figure 2-2) into channel of the Unistrut bracket
(1, figure 2-1).
Figure 2-5. Installing the
Pole Bracket with CSAT
2-6
Revision 1
MN/CSAT506025.IOM
Mounting Plate.