Table of Contents
Advertisement
CDD-880 Multi Receiver Router
Ethernet-based Remote Product Management
6.3.2.6
Admin | VMS
VMS v3.x.x VIPERSAT Management System User Guide (CEFD P/N MN/22156)
Management System Configuration
The acceptable/valid operating ranges for items in this section are provided in parentheses.
•
Network ID (1 to 254) – The Network ID designation defines to which network the Gateway
Router belongs. All devices in a common network will have the same network ID. VMS uses
the Network ID to identify Vipersat units within a network, and allows the VMS to manage
multiple networks, each with its own unique network ID number.
•
Management Base Port– The Management Base Port sets the starting IP port addressing
for all VMS and ACM messages.
CAUTION – MAKE NOTE OF THE FOLLOWING:
•
•
•
Figure 6-10. Admin | VMS Page
Use this setting
ONLY
if network port addressing is in contention. You
should otherwise leave this setting at default (hex) C000 (des) 49152 to
avoid unnecessary configuration changes.
If you change this port number (i.e., enter a value and click [Submit] to
save), it will affect internal management operations across the entire
network. You will be required to make configuration changes to all
modems.
While this page is operational only when the optional VIPERSAT
MANAGEMENT SYSTEM (VMS) is installed and operational, the
Management Base Port number is essential to proper operations with or
without the VMS feature.
6–16
MN-CDD880
Revision 2
Advertisement
Table of Contents
