Table of Contents
Advertisement
CDD-880 Multi Receiver Router
Installation
Once opened, inspect the shipment:
Step
Task
1
Keep all shipping materials.
2
Check the packing list to make sure the shipment is complete.
Inspect the equipment for damage. If damage exists, immediately contact the carrier
3
and Comtech EF Data to submit a damage report.
4
Read the manual.
2.2
Install the Unit Into a Rack Enclosure
Install the CDD-880 in its assigned position in the rack enclosure (Figure 2-2). Use, as required:
•
A standard rack-mounted shelf;
•
User-supplied screws to secure the front panel to the rack enclosure threaded front
mounting rails;
•
Comtech EF Data's optional KT-0000168 (4") or KT-0000195 (10") Rear Support Brackets Kit
(Figure 2-3).
For information about custom rack enclosures, contact Comtech EF Data Product Support.
CAUTION – CORRECT GROUNDING PROTECTION IS REQUIRED TO PREVENT PERSONAL
INJURY AND EQUIPMENT DAMAGE.
You must make sure the ground stud on the rear panel of the unit is always connected
to the protective earth.
SUFFICIENT AIR VENTILATION IS REQUIRED.
Make sure there is adequate air ventilation clearance inside the enclosure, especially
at the side. In a rack system where there is high heat discharge, provide forced-air
cooling with top- or bottom-mounted fans or blowers.
The CDD-880 CANNOT have rack slides mounted to the sides of the chassis. Cooling
fans and exhaust vents are provided here – air flow must not be impeded. Comtech EF
Data recommends that an alternate method of support is provided within the rack,
such as standard rack shelves or the optional Rear-Mounting Support Brackets Kit. If
there is any doubt, contact Comtech EF Data Customer Support during normal
business hours.
MAXIMUM AIR TEMPERATURE.
Make sure the air temperature inside the enclosure
never
2–2
MN-CDD880
Revision 2
exceeds 50°C (122°F).
Advertisement
Table of Contents
