Table of Contents
Advertisement
Chapter 7. SERIAL-BASED REMOTE PRODUCT
7.1
Overview
Serial-based Remote Product Management of the CDD-880 Multi Receiver Router is available using the CDD-880 rear panel 'CONSOLE'
port.
1) The Serial-based Remote Product Management Interface is intended to provide two important capabilities:
•
First, it allows you to establish IP communications (HTTP, SNMP) when the unit is first being configured.
•
Second, the interface allows you to bring the CDM-840 back online through the serial or Telnet Interface over a very
slow speed "backup channel".
This interface is NOT intended to be a full featured interface to configure all aspects of the modem. Rather, its purpose
is to provide enough commands to allow a terminal to be brought back online.
Once communications have been re-established, the standard interfaces (HTTP, SNMP, NetVue) can be used complete
any additional detailed configuration/control/monitoring functions
USE OF THE SERIAL-BASED REMOTE PRODUCT MANAGEMENT INTERFACE IS RECOMMENDED ONLY FOR ADVANCED
USERS.
2) YOU MAY PROCEED WITH SERIAL-BASED REMOTE PRODUCT MANAGEMENT, ASSUMING THAT:
MANAGEMENT
7–1
Advertisement
Table of Contents
