CDD-880 Multi Receiver Router
Appendix H
Do these steps to configure VersaFEC ACM operation from the specified HTTP Interfaces:
1. Using the CDD-880 HTTP Interface (Figure H-4):
•
Use the "Configuration | Network | Assoc. CTOG" page as needed to establish the link
for the CTOG-250 available within the active Advanced VSAT Network.
•
Use the "Configuration | Network | Routing" page as needed to configure (add) a route
from the CDD-880 to the CTOG-250 for the Management IP Address of the CDM-840.
Be sure to click [Submit] on each page as needed to save your settings.
Figure H-4. CDD-880 HTTP Interface – Configuration | Network | Assoc. CTOG and
2. Using the CDM-840 HTTP Interface "Configuration | WAN | Mod | ACM" page (Figure
H-5), click the "List all 880s" hyperlink (located in the header of the "Tx ACM Status" section
on the page) to display all CDD-880s recognized within the active Advanced VSAT Network.
Configuration | Network | Routing Pages
H–8
MN-CDD880
Revision 2