Table of Contents
Advertisement
CDD-880 Multi Receiver Router
Ethernet-based Remote Product Management
Es/No, via the CTOG-250, to an associated CDM-840 that will use this information to adjust its Tx
MODCOD.
ACM Demodulator Settings (Read-only)
This table is auto-populated for each operating demodulator. From left to right:
Column
Demod #
Remote CDM-840 IP Address
Current Es/No
Current Rx MODCOD
Rx ACM Events (read-only)
Event information is logged as sequentially. From left to right:
Column
Date
Time
Demod #
New ES/No
New Rx MODCOD
New Rx Data Rate
840 IP
Click [Show Last 15 Events] to refresh the table with the latest reported ACM statistics.
Click [Clear ACM Events] to clear all ACM statistics from the buffer.
Description
This is the available "FILLED" demodulator slot (automatically assigned in pairs
per each installed dual demodulator card).
This is the CDM-840 Remote Router IP Address, in the form
XXX.XXX.XXX.XXX, This column updates automatically once the demod locks to
the remote.
This is the current Es/No of the demod, in 0.1 dB increments. The displayed
range is from -5 dB to 35 dB.
This is the current MODCOD of the demod. It is used to measure the Current
Es/No.
Description
This is the logged date for the event in MM/DD/YY format.
This is the logged time for the event in HH:MM:SS format.
This is the available "FILLED" demodulator slot (automatically assigned in pairs per each
installed dual demodulator card).
This is the Es/No reported by the receiving demod when the MODCOD switch occurred.
This is the MODCOD that the demod was switched to by the ACM algorithm.
This is the Rx Data Rate at the time of this event.
This is the IP Address assigned at present.
6–24
MN-CDD880
Revision 2
Advertisement
Table of Contents
