Table of Contents
Advertisement
CDD-880 Multi Receiver Router
Introduction
1.3.3
Physical Features
1.3.3.1
Front Panel Features
•
Chapter 2. INSTALLATION
•
Chapter 7. ETHERNET-BASED REMOTE PRODUCT MANAGEMENT
The CDD-880 front panel (Figure 1-4) provides these features:
1
LED Indicators
The front panel features 16 Light-Emitting Diode (LED) indicators. These LEDs convey
operational states as follows:
LED
UNIT STATUS
STORED
EVENT
ONLINE
GE
LINK/ACTIVITY
Rx TRAFFIC 1
through 12
2
Rack Handles
In a rack enclosure, these handles help you install and remove the unit.
Figure 1-4. CDD-880 – Front Panel View
State
Condition
Green
No Unit Faults or Alarms.
Amber
No Unit Faults, but an Alarm exists.
Red
A Unit Fault exists (Example: PSU fault).
There is a Stored Event in the log, which can be viewed from the Web Server
Amber
Interface or retrieved via the remote control interface.
Off
There are no Stored Events.
Green
The Unit is On Line, and carrying traffic.
The Unit is Off Line (standby) – forced by externally connected 1:1 or 1:N
Off
redundancy system.
Green (solid)
Traffic Ethernet is connected, but no traffic exists.
Green (blinking) Ethernet activity detected.
Off
GE Ethernet port is not connected.
Green (solid)
No Rx Traffic Faults (demod and decoder are locked, everything is OK).
No Rx Traffic Faults, blinks when a packet is being received from the satellite
Green (blinking)
link to this unit.
Amber
Rx Traffic has an Alarm.
Red
Rx Traffic has a Fault.
Off
Demod Card is not installed.
1–5
MN-CDD880
Revision 2
Advertisement
Table of Contents
