Table of Contents
Advertisement
CDD-880 Multi Receiver Router
Appendix G
1. If the link is established statically, use the CDM-840 HTTP Interface to do these steps:
a) Use the Configuration | WAN | Mod | Config page to establish the communications
link, set the Modulator Frequency, and select the MODCOD, Symbol Rate and Data Rate.
b) Manually adjust the modulator power until the return path demod locks with good data
(pings).
c) Use the drop-down list in the Tx Dynamic Power Control Configuration section of the
Configuration | WAN | Mod | DPC page to enable DPC. Click [Submit], then allow
power to target (ACM operation is not required).
G–20
MN-CDD880
Revision 2
Advertisement
Table of Contents
Need help?
Do you have a question about the CDD-880 and is the answer not in the manual?
Questions and answers