CDD-880 Multi Receiver Router
FAST Activation Procedure
5.2.1 FAST Configuration
The read-only table in this section displays the CDD-880 available FAST Features and the
operational status for each option:
Column
Description
Option
This column lists each available FAST Feature.
Status
This column identifies each FAST Feature operational parameter(s). If an option is not enabled,
the column displays this information.
The complete roster of FAST Accessible Options is as follows:
Option
Demod Card / VersaFEC
Aggregate Rx Data Rate (CCM)
and Symbol Rate (ACM)
PTP (Precision Time Protocol)
1) Rx Header and Payload Compression are standard (non-FAST) operational features
for Comtech EF Data's Advanced VSAT Series group of products. If these features
are listed in the FAST Configuration table, they are always indicated as Enabled.
2) PTP is not available in this firmware release. Once operable, this protocol will be
used to synchronize clocks throughout a computer network. When the hardware
required for this option is not installed in the CDD-880, this page displays the
message "Disabled (No Hdware")..
Up to six (6) dual demodulator cards installable.
Up to 10 Mbps (CCM) or 4 Msps (ACM)
Up to 25 Mbps (CCM) or 10 Msps (ACM)
Up to 50 Mbps (CCM) or 20 Msps (ACM)
Max Data Rate (CCM) or Symbol Rate (ACM) for use with dSCPC only
NOT AVAILABLE IN THE FW VER. 1.6.2.X RELEASE
5–3
MN-CDD880
Revision 2