Configure Qos Rules Based Switching; Typical System Latency; Figure 3-46 Qos Rules Based Switching Screen; Figure 3-47 Typical System Latency Prompt - Comtech EF Data Vipersat CDM-570 User Manual

V i p e r s a t C o nf i g u r a t i o n
Configure the desired number of rules that are necessary for the applications to
be used for this network. Refer to the CDM-570/570L Installation and Opera-
tion Manual for details on configuring QoS Rules for the CDM-570/570L.

Configure QoS Rules Based Switching

Enter V at the command prompt in figure 3-42 to access the QoS Rules Based
Switching screen for the Remote modem, as shown in figure 3-46.
Figure 3-46
QoS Rules Based Switching screen
Determine which QoS rules will be used as a basis for performing SCPC
switching, then configure the VMS policy type, the SCPC switch rate, and the
timeout value to be associated with each rule. Assigning a 0 (zero) value means
that no SCPC switch will occur for that rule.

Typical System Latency

Enter A at the command prompt in figure 3-42 to configure the Typical System
Latency parameter for the Remote modem, as shown in figure 3-47.
Figure 3-47
Typical System Latency prompt
This setting corresponds to the buffer queue depth and should be set according
to the type of traffic. In the majority of applications, the recommended setting is
V i p e r s a t C D M - 5 7 0 / 5 7 0 L U s e r G u i d e
3-38