Cp Extension Connection - Festo CDVI-DN Manual

1. Installation

1.5.2 CP extension connection

1-30
Advanced diagnostics (supplied load voltage) are only
possible with new manifold blocks or new expansion blocks
with additional electric power supply. These new blocks
are distinguished by the 16-pole electrical connection
(old = 12-pole) and the designation printed on the PCB.
Advanced diagnostics are not possible if old blocks are
combined with new ones.
You can connect further CP modules to the VDVI-DN via the
CP extension connection.
Fig. 1/11: CP extension connection
Note
Modules which you connect to the CP extension connec-
tion are recognized only if the DIL switches are set cor-
rectly.
Information on setting the DIL switches can be found in
section 1.2.2.
You can connect the following CP modules to the CP exten-
sion connection:
– CP input module with 8 or 16 inputs, either with M12
plugs (sockets assigned twice) or M8 plugs (sockets as-
signed once)
– CP input module (IP 20) with 16 inputs
CP
Festo P.BE-CDVI-DN-EN en 0805a