Festo CDVI-DN Manual page 29

1. Installation
1.3.4 Pin allocation of the DeviceNet
Festo P.BE-CDVI-DN-EN en 0805a
Note
Make sure you check the pin allocation of your scanner
with the relevant documentation.
The bus connection is established at "Bus in". Use a 5-pin M12
socket from Festo for this purpose (type:FBSD-GD-9-5POL).
The fieldbus is continued at "Bus out". Use a plug of type
FBS-M12-5GS-PG9 for this purpose.
For the position of these connections, see also Fig. 1/1.
The following table shows the connection between the wire
colour, signal and pin allocation:
*)
Wire colour
Blank
Red
Black
White
Blue
BUS OUT
*)
typical for DeviceNet cables
Tab. 1/8: Pin allocation of the DeviceNet
Signal
Screen
24 V DC bus
0 V bus
CAN_H
CAN_L
BUS IN
PIN
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
1-17