Festo CDVI-DN Manual page 67

2. Startup
Festo P.BE-CDVI-DN-EN en 0805a
"Idle Action, Main Unit" parameter
You can use this parameter to define for each output whether
it is to freeze the current status in idle mode or whether it is
to assume a certain output status (0/1).
Parameter Meaning
value
0 The output is set to a certain output status (0 or 1).
The output status is defined with the "Idle Value,
Main Unit" parameter.
1 The status of the output is frozen.
"Idle Action, Main Unit" parameter
You can use this parameter to define which output value
(0 or 1) each output is to assume in idle mode.
Parameter Meaning
value
0 Output is reset
1 Output is set
The set parameter value is only taken into account if the rel-
evant output is set to 0 in the Fault Action parameter.
"Idle Action, Main Unit Extension" parameter
The same function as above with "Main Unit," but for the
output module in the CP extension.
"Idle Value, Main Unit Extension" parameter
The same function as above with "Main Unit," but for the
output module in the CP extension.
2-23