Festo CDVI-DN Manual page 36

1. Installation
1
Cable
2
Strain relief
3
Housing
4
Connecting part
Fig. 1/8: Individual plug parts and cable bushing
Preparing
1-24
Mounting the connector socket
1
4
Once you have selected appropriate cables, connect them as
follows (Fig. 1/8):
1. To open the plug, loosen the central knurled nut.
2. Open the strain relief on the rear part of the housing.
Then pass the cable through.
3. Remove 5 mm of insulation from the end of the conduc-
tors and fit wire end sleeves on the stranded wires.
4. Connect the ends of the conductors.
5. Replace the connector part on the housing of the plug.
Pull back the cable until there are no loops inside the
housing.
6. Tighten the strain relief.
Festo P.BE-CDVI-DN-EN en 0805a
2
3