Binary Input "X" Configuration Dialogs; Enable Use Of Input "X - IntesisBox IS-IR-KNX-1i User Manual

KNX – IR Universal AC
®
IntesisBox
➢ Reload last On/Off value when Occupied
If set to "no", once the switch-off timeout has elapsed, any value will be reloaded.
If set to "yes", once the switch-off timeout has elapsed, the last On/Off value will be reloaded.
• If a "1" value is sent to the Control_ Occupancy object after the timeout period, the indoor unit
will turn on.
• If a "0" value is sent to the Control_ Occupancy after the timeout period no action will be
performed.
➢ Lock ON when occupied
If set to "no", On/Off commands while the room is occupied will be accepted.
• If a "1" value is sent to the Control_ Switch Off Timeout object the switch-off timeout period will
begin again.
• If a "0" value is sent to the Control_ Switch Off Timeout object, no action will be performed.
If set to "yes", On/Off commands, while the window is open, will be saved (but not applied). These
commands will be used in the next parameter if set to "yes".

Binary Input "x" configuration dialogs

All the parameters in this section are related with the binary inputs properties and communication objects.

5.11.1 Enable use of Input "x"

This parameter enables the use of the Input "x".
If set to "no" the objects will not be shown.
o
If set to "yes" the Status_ Inx object(s) and new parameters will appear.
o
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox ® is a registered trademark of Intesis Software SLU
User's manual r1.0 eng
URL http://www.intesisbox.com
Email info@intesisbox.com
tel +34 938047134
38 / 48