Enable Use Of Occupancy Function - IntesisBox IS-IR-KNX-1i User Manual

KNX – IR Universal AC
®
IntesisBox
• If a "0" value is sent to the Control_ Switch Off Timeout after the timeout period, no action will
be performed.
➢ Lock ON when Open
If set to "no", On/Off commands while the window is open will be accepted.
• If a "1" value is sent to the Control_ Switch Off Timeout object the switch-off timeout period will
begin again.
• If a "0" value is sent to the Control_ Switch Off Timeout object, no action will be performed.
If set to "yes", On/Off commands, while the window is open, will be saved (but not applied). These
commands will be used in the next parameter if set to "yes".

Enable use of Occupancy function

This parameter shows/hides the Control_ Occupancy Input communication object which lets you apply different
parameters to the indoor unit depending on the presence/no presence in the room.
If set to "no" the object will not be shown.
o
If set to "yes" the Control_ Occupancy object and new parameters will appear. If a "1" value is sent to this
o
object (no room occupancy), the timeout will begin. If a "0" value is sent to this object, the timeout will stop.
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox ® is a registered trademark of Intesis Software SLU
Figure 4.33 Parameter detail
User's manual r1.0 eng
URL http://www.intesisbox.com
Email info@intesisbox.com
tel +34 938047134
36 / 48