Enable Use Of Open Window - IntesisBox IS-IR-KNX-1i User Manual

KNX – IR Universal AC
®
IntesisBox
Important: If any preset value is configured as "(unchanged)", the execution of this scene will not
change current status of this feature in the AC unit.
Important: When a scene is executed, Status_ Current Scene object shows the number of this scene.
Any change in previous items does Status_ Current Scene show "No Scene". Only changes on items
marked as "(unchanged)" will not disable current scene.

Enable use of Open Window

This parameter shows/hides the Control_ Window Contact Input communication object which lets you Start/Stop
a timeout to switch off the indoor unit.
If set to "no" the object will not be shown.
o
If set to "yes" the Control_ Window Contact Input object will appear. If a "1" value is sent to this object,
o
and the indoor unit is already turned on, the switch-off timeout will begin. If a "0" value is sent to this object,
the switch-off timeout will stop.
➢ Input Object
This parameter lets you choose between the datapoints 0-Open / 1-Closed Window [DPT_1.009] and
0-Stop / 1-Start Timeout [DPT_1.010] for the Control_ Switch Off Timeout.
➢ Timeout (min)
This parameter lets you select how much time (in minutes) to wait before switching off the indoor unit.
➢ Reload last Value
If set to "no", once the switch-off timeout is stopped, any value will be reloaded.
If set to "yes", once the switch-off timeout is stopped, the last On/Off value sent will be reloaded.
• If a "1" value is sent to the Control_ Window Contact Input object after the timeout period, the
indoor unit will turn on.
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox ® is a registered trademark of Intesis Software SLU
User's manual r1.0 eng
URL http://www.intesisbox.com
Email info@intesisbox.com
tel +34 938047134
35 / 48