Setup - GE Sievers 900 Series Operation And Maintenance Manual

• Setup — Set the Analyzer mode and change parameters such as reagent flow rates and, in
Grab mode, the number of repetitions and the number of rejects.
• Data — Display and export historical data stored in RAM.
• I/O — Configure the input and output of data from the Analyzer.
• Maintenance — Display information about the Analyzer's consumables levels, system
information, and error messages. Also perform calibration and system suitability
operations.
• DataGuard — Configure the access settings and user passwords for your Analyzer.
From any tab under the Menu screen, you can press the Start Analysis button to initiate TOC
measurements.

Setup

Setup
Options on the Setup tab let you specify preferences and basic operation settings for the Analyzer
configuration. If the sample conditions for your application remain relatively constant, you should
seldom need to configure the settings here, especially if you use the Autoreagent flow rate setting.
GE Analytical Instruments ©2009
Setup Data I/O
On-Line
Grab
Enable Turbo
Main Start Analysis
Figure 12: The Setup Tab
4 Mar 2004 08:20
Maintenance DataGuard
Configure Mode
Logout
92 of 236 DLM 90488-01 Rev. A