Quick Setup Instructions - Cisco D9865 Installation And Configuration Manual

Quick Setup Instructions

A "No signal" message is displayed on the TV monitor. To set up your receiver for your network to
Step 4
receive your authorized programs, refer to
Quick Setup Instructions
The following instructions are for use with the Remote Control.
Display the MAIN MENU by pressing MENU.
Step 1
Step 2 Press the
Step 3 Move to the Tuning / Preset menu and press OK.
Step 4 Enter or select the following parameters on this menu from your service provider. Refer to
Front Panel, page 3-1
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
Receivers with Factory Pre-configured Presets
If the receiver has been factory pre-configured with presets, press the yellow button to go to the Preset
/ LNB Setup menu to view the presets and select the one for your network.
You need to press OK to view the parameters and Name of the preset.
Note
Once you have selected your network preset by scrolling through the presets in the Preset field, press
the blue button to Activate the displayed preset as the current preset.
Go to Step 5.
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
1-2

button to move to the Setup Menu and press OK.
for instructions on the use of the arrow buttons.
Enter the Modulation Type (DVB-S, DVB-S2).
Enter the Downlink Frequency (in GHz).
Enter the Symbol Rate (in MS/s).
Enter the NetId.
Select LO Select (On, Off, Auto) when using a Ku-band dual LNB. This controls the 22 kHz tone.
Enter LO Freq 1 (in GHz) based on C or Ku-Band LNB operation (e.g., 9.75 for Ku-Band, 5.150
for C-Band).
Enter LO Freq 2 (in GHz). Use this when using a Ku-band dual LNB. LO Freq 2 > LO Freq 1.
Enter the Crossover frequency when using a Ku-band dual LNB.
Enter the LNB Power. Turn on if using the receiver to power the LNB.
Select DiSEqC (if required). This allows control of the satellite dish motor.
LNB Power must be on to use DiSEqC functions.
Note
Select the LNB port for the DiSEqC Switch (if used).
The LNB power alarm will be on if LNB power is on for use with a DisEqC switch, but
Note
external power is also used.
Quick Setup Instructions, page
Chapter 1 Quick Setup
1-2.
About the
OL-31085-01