Configuring Favorites And Reminders - Cisco D9865 Installation And Configuration Manual

Configuring Favorites and Reminders

From the Date Format drop-down list, choose the date format of the receiver. The following formats are
Step 2
supported: YYYY/MM/DD, DD/MM/YYYY, MM/DD/YYYY.
Step 3 From the Time Format drop-down list, choose the time format of the receiver. Time information is
normally broadcast as part of the transmitted digital signal. It is usually the broadcaster local time
relative to Greenwich Mean Time (GMT). The following formats are supported: 24 Hr, 24 Hr
SuspendZero, 12 Hr, 12 Hr SuspendZero.
From the GMT Time Offset drop-down list, choose the time displayed using a time zone instead of the
Step 4
true local time. If the current broadcast time is not your local time, you must change this time setting in
the range from -12:00 to +13.00 in one hour increments.
The Current Time displays the current date and time, according to the date and time formats set.
Step 5
Click Apply.
Step 6
Configuring Favorites and Reminders
Proceed as follows to configure the favorites and reminder settings of the D9865 receiver:
From the user interface of the D9865, choose System Settings > System > Favorites & Reminders.
Step 1
The Favorites & Reminders page is displayed.
The Favorites area lists all the favorite profiles configured in the D9865. Favorites allow you to surf
Step 2
through the channels you have set up as your favorite channels, skipping over other channels. By default,
All Channels (authorized or unauthorized channels) are displayed. Click the Authorized Channels
Only radio button to browse channels that are authorized by your uplink provider only.
The One Button Channel Change area allows you to assign a channel to each of the colored buttons at
Step 3
the bottom of the remote control (see below).
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
5-40
Chapter 5 Setup and Monitoring via Web GUI
OL-31085-01