Cisco D9865 Installation And Configuration Manual page 54

Setup Menu
Selection
LNB Power
(For more information,
see LNB Power
Settings, page
LO Freq1
LO Freq2
Crossover
LO Select
(Sets a 22 kHz tone for
Ku-band dual LNB)
DiSEqC
DiSEqC Switch
If you enter an invalid frequency setting or a setting that does not correspond to the selection, a pop-up
Note
message such as "Input value out of range" is displayed.
Step 3 Press the green button (Save) to save your settings.
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
4-20
Options
18-H
13-V
Off
4-21.)
H-NIT
V-NIT
Enter number
Enter number
Enter number
Off
On
Auto
Enable
Disable
Off
A to P
Chapter 4 Setup and Monitoring via On-Screen Display
Description
For H polarization.
For V polarization.
Use for external LNB power.
LNB power must be on if DiSEqC is required.
Initially applies the horizontal polarization
voltage, and then follows the polarization based on
the NIT.
Initially applies the vertical polarization voltage,
and then follows the polarization based on the
NIT.
If C-band application, set to 5.15 GHz (default).
If Ku-band single LNB, enter LO Freq. and set LO
Freq 2 and Crossover to 0.0.
If Ku-band dual LNB, enter LO Freq 1, LO Freq 2
and Crossover.
Enter if Ku-band dual LNB application. LO Freq 2
> LO Freq 1.
Enter if Ku-Band dual LNB application. Used to
determine if LO Freq 1 or LO Freq 2 is used for
tuning.
Switches 22 kHz tone off.
Switches 22 kHz tone on.
Sets 22 kHz tone to automatic.
If Downlink Freq < Crossover use LO1. The 22
kHz tone is Off.
If Downlink Freq > Crossover use LO2. The 22
kHz tone is On.
Enables or disables Digital Satellite Equipment
Control, level 1.2. This must be enabled to control
the DiSEqC switch. LNB Power must be on to use
this setting. Refer to
http://www.eutelsat.com/satellites/4_5_5.html
more information.
Selects a port on the LNB switch (if used).
for
OL-31085-01