Viewing The Rf Status - Cisco D9865 Installation And Configuration Manual

Chapter 4 Setup and Monitoring via On-Screen Display
Active Warning Information
Name of Warning
Set Since
Details

Viewing the RF Status

Proceed as follows to view the RF status:
From the Info screen, select RF Status and press OK.
The following table describes the RF Status information displayed:
RF Status
Downlink Frequency
Symbol Rate
Polarization
FEC
LO Freq 1/2
Crossover
AFC
OL-31085-01
Description
Name of the warning. For more information on warning messages,
refer to Warning Messages, page
Date and time of the warning.
Displays the content of the message.
Description
Indicates the current downlink frequency, in GHz.
Indicates the Symbol Rate of the received signal, in MS/s.
Indicates the signal polarization setting. This setting is only
applicable when LNB Power is set to H-NIT or V-NIT. The selected
setting must match the polarization of the transmitted signal.
Indicates the FEC (Forward Error Correction) rate of the received
signal.
Displays the Local Oscillator frequency #1 and #2.
Indicates the crossover frequency, which is an internal threshold
frequency used for selecting the LO1 or LO2 frequency, depending
on the current Downlink frequency setting. This is only used in
Ku-Band dual LNB application.
Indicates the current Automatic Frequency Control adjustment, in
MHz.
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
Setup Menu
6-10.
4-65