Setting Up Snmp - Cisco D9865 Installation And Configuration Manual

Setup Menu
Editing a Multicast IP Address
In the Multicast IP Setup screen, scroll to the multicast IP you want to edit using the
Step 1
Press OK. The Edit/Delete Multicast IP screen is displayed.
Step 2
Select Edit or press the blue button (Edit). The Add/Edit Multicast IP screen is displayed.
Step 3
Make the necessary changes.
Step 4
Press the green button (Save) to save your changes.
Step 5
Deleting a Multicast IP Address
In the Multicast IP Setup screen, scroll to the multicast IP you want to delete using the
Step 1
Press OK. The Edit/Delete Multicast IP screen is displayed.
Step 2
Select Delete or press the red button (Delete). A message appears to confirm the deletion.
Step 3
Press OK.
Step 4

Setting up SNMP

Proceed as follows to configure SNMP:
From the Network Setup screen, select SNMP Setup and press OK.
Set the Read/Write Community String to public or a custom string. The SNMP Community
Read/Write is used when communicating with a device within an SNMP environment. These commands
allow you to set the password to read and write data to a device to display diagnostics traps/alarms. The
default community string is public. To set a custom community string, enter an alphanumeric character
string up to 31-characters in length identifying the password for the device.
Note
Viewing Trap Destinations
You can assign up to 10 entries to the Trap Destination and Community String fields.
Note
Proceed as follows to view trap destinations:
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
4-48
The community string is case-sensitive.
Chapter 4 Setup and Monitoring via On-Screen Display

buttons.

buttons.
OL-31085-01