Cisco D9865 Installation And Configuration Manual page 58

Setup Menu
Selection
DiSEqC
Step 6 Press the blue button (Do Action) to save and apply the settings to the receiver until the next reboot.
Step 7 The following table describes the view-only information on the Dish Setup screen:
Parameter
Modulation
LDPC BER
Mode
NW Name
PV BER
PER
DiSEqC Status
Signal Quality
Signal Level
Signal Lock
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
4-24
Options Description
Enable Enables or disables Digital Satellite Equipment
Satellite Control, level 1.2.
Disable
Note
Before you can adjust the satellite position using
the Adjust Dish Position screen or a signal tone,
ensure that the LNB Power and DiSEqC (in the
Tuning/Preset screen) are enabled.
Description
Indicates the modulation type for the received signal.
Indicates the bit rate of the input stream of the LDPC error
correcting stage (DVB-S2 only).
Indicates whether the current dish setup mode is Installer or User.
The mode can be changed by pressing the yellow button.
Displays the network name.
Indicates the PV (Post-Viterbi) BER for the received signal
(DVB-S).
Indicates the current PER (Packet Error Rate).
Indicates whether the DiSEqC is enabled or disabled.
Indicates the quality of the received signal, associated with the Bit
Error Rate, in the range from 0 to 100.
Displays the relative strength of the received RF input signal. It is
displayed in the range from 0 to 100.
Indicates whether the receiver is synchronized with the received RF
signal.
Chapter 4 Setup and Monitoring via On-Screen Display
This must be enabled to control the
DiSEqC switch. LNB Power must be on to
use this setting. Refer to
http://www.eutelsat.com/satellites/4_5_5.
html for more information.
OL-31085-01