Cisco D9865 Installation And Configuration Manual page 78

Setup Menu
Editing an IP Address
Proceed as follows to edit the Network IP Address:
From the IP Setup screen, press the yellow button (SetIPAddr).
Step 1
Make the necessary changes. The following table describes each of the options:
Step 2
Selection
IP Address
Mask
Gateway Address
The Network Address, Prefix Mask, and Gateway Address should be changed together, as a group. The
following table shows the most commonly used Subnet mask values to enter for a chosen IP address
mask, which will depend on the size of your network.
Mask
8
16
24
Note
Press the green button (Save) to save your changes.
Step 3
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
4-44
Options
12 digits in length
(###.###.###.###)
8 to 32
12 digits in length
(###.###.###.###)
Only Port 1 is available for this release.
Chapter 4 Setup and Monitoring via On-Screen Display
Description
Sets the IP Address for its participation in
a Network environment.
Sets the Subnet Mask for its participation
in a Network environment.
Sets the Network Gateway Address on the
Network, used to expose the receiver to a
WAN.
Subnet Mask
255.0.0.0
255.255.0.0
255.255.255.0
OL-31085-01