Quick Setup Instructions - Cisco D9865 Installation And Operation Manual

Quick Setup Instructions

The following instructions are for use with the Remote Control.
1. Display the MAIN MENU by pressing MENU.
2. Press the
3. Move to the Tuning / Preset menu and press OK.
4. Enter or select the following parameters on this menu from your service
provider. Refer to About the Front Panel, on page 3-2 for instructions on the use
of the arrow buttons.
• Enter the Modulation Type (DVB-S, DVB-S2).
• Enter the Downlink Frequency (in GHz).
• Enter the Symbol Rate (in MS/s).
• Enter the NetId.
• Select LO Select (On, Off, Auto) when using a Ku-band dual LNB. This
controls the 22 kHz tone.
• Enter LO Freq 1 (in GHz) based on C or Ku-Band LNB operation (e.g., 9.75 for
Ku-Band, 5.150 for C-Band).
• Enter LO Freq 2 (in GHz). Use this when using a Ku-band dual LNB. LO Freq
2 > LO Freq 1.
• Enter the Crossover frequency when using a Ku-band dual LNB.
• Enter the LNB Power. Turn on if using the receiver to power the LNB.
• Select DiSEqC (if required). This allows control of the satellite dish motor.
Note: LNB Power must be on to use DiSEqC functions.
• Select the LNB port for the DiSEqC Switch (if used).
Note: The LNB power alarm will be on if LNB power is on for use with a
DisEqC switch, but external power is also used.
Receivers with Factory Pre-configured Presets
If the receiver has been factory pre-configured with presets, press the yellow button
to go to the Preset / LNB Setup menu to view the presets and select the one for your
network.
Note: You need to press OK to view the parameters and Name of the preset.
Once you have selected your network preset by scrolling through the presets in the
Preset field, press the blue button to Activate the displayed preset as the current
preset.
Go to Step 5.
1-2

button to move to the Setup Menu and press OK.
D9865 Satellite Receiver Installation and Operation Guide 4035197 Rev C