Cisco D9865 Installation And Configuration Manual page 170

Warning Messages
Warning Set Message
Restore Failure FTP Failed
Reason
HDMI:Not an Auth HDCP authentication
Device failed
HDMI:Not an Auth Receiver not HDCP
Device capable
TV-Out Settings Invalid configuration
Problem data
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
6-12
Cause Remedy
FTP failed due to a Check FTP
possible software issue. configuration, reset
unit, and notify Cisco
customer support if
problem persists.
HDMI monitor is not Disconnect HDMI
authorized to receive monitor to restore video
HDMI content and does decode or use an HDMI
not contain valid HDCP monitor that properly
keys. Video decode is supports HDCP.
disabled.
HDMI monitor is not
connected.
Connect an HDMI or
DVI capable monitor, if
desired.
HDMI monitor is not Disconnect HDMI
authorized to receive monitor to restore video
HDMI content and it decode or use an HDMI
does not support HDCP. monitor that properly
Video decode is supports HDCP.
disabled.
Incorrect TV-Out video Check the video setup
setup settings. settings: TV Channel
Number and SD Video
Output format. For PAL
device, use channel 21
through 69 and SD
Format PAL-x. For
NTSC device, use
channel 3 or 4 and SD
Format NTSC or
NTSC-J. Notify
customer service if
problem persists.
Chapter 6 Service and Maintenance
Clear Message
Auto reset after timeout
HDCP authentication
success
HDCP Authentication
Process Not Started
Valid configuration data
OL-31085-01