Viewing The Network Setup Menu (D9865D Only) - Cisco D9865 Installation And Configuration Manual

Chapter 4 Setup and Monitoring via On-Screen Display
Set the Acquisition Mode used to build channel lists from allowed service lists (Basic, Auto, or
Step 3
Custom). Select Custom to customize the tables used to obtain tuning and channel lists.
Step 4 If the Acquisition Mode was set to Custom, you can set the Tuning Source to indicate whether the
receiver is tuned to the received signal using the NIT or a Preset. The default is NIT.
Step 5 The Service List Mode indicates which tables are used to obtain tuning and channel lists. This only
applies when Acquisition Mode is set to Custom. Select Rigorous if all default settings must be present
in the received signal. Select Degraded and only the table parameters present in the received signal will
be used to install the receiver.
The following table displays the default settings for the allowed service lists and frequency tuning
settings.
Allowed Service lists
BAT
NIT
SDT
PAT
Tuning Source

Viewing the Network Setup Menu (D9865D only)

Proceed as follows to view the Network Setup screen (D9865D only).
From the Advanced Setup menu, select Network Setup and press OK.
The function for the available sub-menus is as follows:
•
•
•
OL-31085-01
Auto
No
Yes
Yes
Yes
NIT
IP Setup
From this menu, you can configure the receiver for Ethernet operation.
–
Unicast IP Setup
From this menu, you can configure network destinations for unicast transmission.
–
Multicast IP Setup
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
Basic Custom
No No
Yes No
No No
No Yes
NIT Preset
Setup Menu
4-41