Cisco D9865 Installation And Configuration Manual page 83

Chapter 4 Setup and Monitoring via On-Screen Display
From the SNMP Setup screen, press the yellow button (Trap Dest) to view trap destinations.
The Trap Destination Setup screen displays a list of trap destination addresses and the associated
community string.
Adding Trap Destinations
Proceed as follows to add trap destinations:
From the Trap Destination Setup screen, press the green button (Add) to add a trap destination address.
Step 1
The following table describes each of the available options:
Step 2
Selection
Trap Destination
Address
Community String
OL-31085-01
Options
Up to 12 digits in length (e.g.,
155.128.100.200)
public or custom string. Up to 31
characters.
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
Description
Enter the destination for SNMP trap
messages for events (i.e., fault messages).
Set the community string for the trap IP
address above. The default is public.
Setup Menu
4-49